Mazda ha il DPF non FAP.
Modificato il titolo
Se è solo intasato la rigenerazione forzata dovrebbe risolvere il problema.
Qui è spiegata una procedura:
"MANUAL DIESEL PARTICULATE FILTER (DPF) REGENERATION PROCEDURE.
1. BEST to Start This Process AFTER your short Distance Return Journey so engine is still warm-hot.
2. DO NOT Start Process on Stone Cold Engine as REGEN will take Longer.
3. Within SIX (6) Seconds of starting the engine, ''Press and Hold down'' the "TCS OFF" or "DSC OFF (Traction/Dynamic Stability Control) BUTTON for 2-5 Seconds (Maximum) to Start the compulsory DPF Regeneration.
Your Diesel Engine idle will Automatically raise to about 1750 RPM for 15-25 minutes until the DPF Regeneration Process is completed.
NOTE:
DO NOT Hold down this "TCS OFF" or "DSC OFF" BUTTON Any longer than 10 (ten) Seconds or the DTC C0089:64 (Diagnostic Trouble Code) and Dash Meter ''CEL'' Check Engine Light will be set On.
The Glow Plug indicator Light will flash during this DPF Regeneration.
DPF Regen is finished when the Glow Plug indicator Light Stops Flashing and Engine RPM returns to Normal IDLE after the 15-25 minutes.
You can then after either Drive Car and or Turn Engine OFF and Park Car/Lock as normal.
WARNINGS:
1. Make sure your vehicle has a Minimum of ¼ TANK of Diesel Fuel inside Fuel Tank.
2. Make sure car is Parked/Braked and well ventilated (Do Not perform in an enclosed roofed area).
3. Do Not Start this MANUAL Regeneration Process and then decide to drive car or Stop this process.
4. Your CAR MUST NOT BE USED AND MUST BE STATIONARY for the 15-25 MINUTES.
5. IF you can not find the 25 minutes spare time, then Please Do Not start this Manual DPF Regen process."
Fonte:
https://forums.whirlpool.net.au/archive/91j0kll3